Installation Guide

Hardware Installation

Controller Location

The Hydrawise Controller is designed for installation in a protected location.

Cable Entry

The controller has 2 cable entry options – from the rear of the case or via a conduit from

the bottom of the controller.

Mounting the Controller

1. Using a drill bit of 3/16 inch diameter, drill a hole of to a depth of 1 inch (25mm).

2. Insert plastic anchor so it is flush with the surface of the wall.

3. Screw 1 inch screw into plastic anchor leaving the head protruding about 1/8 inch.

4. Slide the controller case over the screw head.

5. Mark second mounting point (see ! in diagram), remove controller, drill hole, insert

plastic anchor, slide controller case over first screw head and screw into place.

The chosen location must have WiFi coverage. WiFi coverage can be easily

checked using an iPhone or smart phone that has WiFi connectivity or on the

Hydrawise unit itself (signal strength is shown when you select a wireless name).

Entry from rear of controller

Using a sharp knife remove the 2

cutouts on the rear of the

controller as indicated on the

diagram as "

Entry via ¾ inch conduit

Using a sharp knife cut around the

semi-circular line on the controller as

indicated on diagram as #. Cut

around the matching line on the blue

controller wiring cover