Installation Guide

Connecting to a WiFi network

When your controller is first powered on it will run a short wizard to connect your

controller to your wireless access point.

1. Select your wireless network from the list shown on the controller display and press

the Confirm button on screen.

2. Enter your wireless password and press the OK button on keyboard.

You can now go to the Hydrawise web site or Hydrawise app to complete configuration.

Hydrawise App Configuration

1. If you have not already done so, create an account at the Hydrawise web site. Go to

http://hydrawise.com/try-now and register for an account.

Log into your account

2. Log into your account. If this is the first time that you have logged in you will be

guided through a setup wizard to help you with initial configuration of your controller.

If your network is not listed then check that the unit is within wireless range.

Make sure you press the OK button after you’ve entered your password.

Pressing the Home or Back buttons will not save your changes.

When connecting to your wireless, the WiFi Icon at the bottom right of the

controller screen will flash. Connecting takes about 30 seconds and when

successfully connected the WiFi Icon will stop flashing and stay on.