Installation Guide

the pipe or object, plus 1/2 inch (12.7mm) for expansion/contraction. Lay the two short sides of the
boards together, then drill the hole centered on the joint between the boards as shown. Now you can
separate the two boards and install as normal. See Diagrams 6A – 6C.
Transitions, moldings, and wall base
Waterproofing: When trying to create a totally waterproof area, you will need to run a small bead of 100%
silicone around the perimeter, this can be done as you are installing your base (under the base), or after the
base has been installed (in front of the base), and under all transitions. This will create a permanent seal
around the perimeter to keep water from absorbing through the edges under the base and trim.
T transitions are recommended in all doorways to allow each room to move independently. All transition
pieces should be attached to the subfloor using the recommended attachment method for the transition
purchased. Never attach the transitions directly to the flooring using nails, screws, or adhesives. All transition
moldings must also be sealed to the flooring using a small bead of 100% silicone between the transition
moldings and the flooring. Be sure to wipe off any excess silicone using mineral spirits paint thinner, or
denatured alcohol, and a clean cloth. When cured, 100% silicone is rubberized and will allow the floor to move
while preventing topical moisture from penetrating under the transition molding.
Note: Waterproof Protection against topical moisture/spills, excludes damage from flooding. Topical
Moisture/Spills should be wiped up as soon as possible.
Finishing The Job:
Inspect your work, as it will cost you more if you have to come back to do a repair later. Replace original
baseboards, or install matching baseboard. Install matching transitions as needed or recommended by your
dealer or installer. It is not recommended or necessary to use a topical sealer on this floor after installation.
Protect your floor from scratches by using felt pads on chair legs or furniture feet. Plastic rollers/castors can
damage your flooring; if necessary try to replace with softer rubber wheels/castors. When moving heavy items
like refrigerators, use at least two sheets of 1/4" Masonite or plywood while moving (sliding the appliance
from one sheet to the next) to protect the flooring against scratching and denting.
Congratulations!
You have just installed a beautiful, and elegant Wellmade HDPC® Hardwood / Strand Bamboo Floor!
Warranty:
For a copy of the warranty, please go to: http://wellmadefloors.com/HDPC_warranty-install
HDPCWOODSTRANINST03132019