Full Product Manual

Caution! Do not touch the inside of the reflector and do not use water, abrasives or detergents to clean it. This will
damage the reflective surface.
Caution! Wait 20 minutes before activating the fixture after maintenance work has been conducted.
• Regularly check the fixture for dust or dirt buildup. Clean if necessary.
• Contamination may cause overheating and decreased performance.
• Clean the inside of the reflector only with a soft, dry cloth.
• Clean the electric ballast and the outside of the fixture using a dry or damp cloth.
• Check the lamp monthly for discolorations or black markings. Always replace a damaged lamp.
• Regularly check the wiring of the fixture to ensure it is undamaged.
8.1. Placement and Replacement of the Lamp
Caution! Do not touch the lamp with bare hands as this will damage the lamp.
Always use a fabric glove to handle the lamp.
Note: The lamp must be replaced every year or after 5000 lighting hours, whichever one comes first.
• Hold the lamp with a fabric glove to prevent it from falling. Use a protective glove if the lamp is damaged.
• Align the pin of the lamp with two holes of the base, insert and screw the lamp into the base.
• Plug the fixture back into the mains.
8.2. Placement and Replacement of the Reflector
Note: You have to remove the lamp to replace the reflector.
Depending on the environment and contamination levels the reflector will degrade.
• Loosen the screw and ring on the top of the bracket.
• Remove the reflector.
• Place the new reflector, tighten the screws.