Instructions / Assembly

Parts List Reflector Assembly
22–M4 wing nuts
38–M4*8 screws
2 –Side Aluminum sheet
2 –End Aluminum sheet
1 –Central Aluminum sheet
4 –Corner steel plates
1 –Support frame with socket kit
2 –V-hooks for hanging
Lamp Installation
1. Open up both the cover of lamp holders.
2. Install the lamp after the lamp is locked by latch.
3. Once lamp is positioned correctly close the cover of the lamp holders to secure and lock the lamp in
place.
4. Installing the double ended lamp within the lamp holders shown in the following photos below.
Please note: During installation try to minimize excessive handling of the lamp to minimize fingerprints and
oils left on the lamp. If the lamp needs cleaning use a soft dry cotton cloth to wipe of finger prints or oils.
ATTENTION：Please make sure the wire of the lamp is straight when you install the lamp. If not, the lamp
will not connect securely with the socket.