Instruction Manual

ManualsBrandsHydro-Logic ManualsAccessories for water3/8 FLOW MASTER Digital Flow Meter

3/8” FLOW MASTER Digital Flow Meter Manual

Step 1:

Install 2 AAA Batteries

as shown in drawing

Step 2: Install Flowmaster on the

product (purified water) line.

Cut tubing and push firmly

into fittings.

Programing the Flowmaster:

Filter Capacity Gallons

2. There is a possibility of

programming 6 dierent

lter capacities. Use only

lter position #1 for this

application.

**** PLEASE NOTE ****

1. You only have 5 seconds

between each step, or the

screen will go blank.

1. Press the “Filter” button to light up the LCD screen. The dot should be under filter position

#1. If it is not, push the “Filter” button until the dot is under #1.

2. Program the metering units: Using a small sharp pin or something similar, lightly press the

setting button located above the top right corner of the screen. Press the “Filter” button to toggle

through the four possible metering unit modes. For filter capacities with four digits, set the units

to “gallons”. For filter capacities with five digits, set the units to “gallons x 10”.

3. Program the filter capacity: After programing the units, press the “Setting” button to toggle

through each of the four digits, and set each of the four digits according to the table above.

Press the “Filter” button to increase the number from 0 to 9 while the LCD screen is flashing.

4. The Flowmaster will memorize the setting automatically after pausing for 5 seconds.

5. Note the four bars on the left hand side of the screen which show that the setting was stored

sucessfully.

6. There is an option to program the “Monthly Lifetime Setting”. However, this application does

not require this option. PLEASE SKIP THIS SETTING.

7. Resetting the unit: After the filter capacity has reached it’s set life, a buzzer will sound to

alert the user to replace the filter. After replacing the filter, press the “Reset” button. The

accumulated number of gallons will be reset to zero and a new filter life begins.

Merlin-Garden Pro 1,500

Merlin-Garden Pro w/ Tall Blue 4,500

Merlin-Garden Pro w/ Tall Blue w/ KDF85 Filter 9,000

Evolution-RO1000 2,000

Evolution-RO1000 w/ Pre-Evolution 7,500

Tall Boy 7,500

Tall Boy w/ KDF85 Filter 15,000

- See Reverse -

PURIFICATION SYSTEMS

For Use With: Evolution RO1000, Merlin Garden Pro, TallBoy, Tallboy w/ KDF

Summary of content (2 pages)

PAGE 1
P U R I F I C AT I O N S YS T E M S 3/8” FLOW MASTER Digital Flow Meter Manual For Use With: Evolution RO1000, Merlin Garden Pro, TallBoy, Tallboy w/ KDF Step 1: Step 2: Install 2 AAA Batteries as shown in drawing Install Flowmaster on the product (purified water) line. Cut tubing and push firmly into fittings. Programing the Flowmaster: **** PLEASE NOTE **** 1. You only have 5 seconds between each step, or the screen will go blank. 2.
PAGE 2
P U R I F I C AT I O N S YS T E M S FLOW MASTER Programing Example 1. Below is an example of how to program the Flowmaster for the Tall Boy with KDF85. We will program a capacity of 15,000 gallons for this example. 2. Press the “Filter” button. Press the “Setting” button. Press the ”Filter” button until the lower right hand side of the display flashes “Gallon x 10”. Press the “Setting” button three times, until the second digit from the left flashes. Press the “Filter” button until it reads “5”.