Installation Instructions

13
Hydro Massage Products LLC • 303-341-1845 | FAX: [phone] • www.hydromassageproducts.com • [e-mail]
PLUMBING
After securing tub in place, waste and overow, water spout and valves are installed per normal
plumbing procedures, in accordance with all state and local standards.
Install standard 1 1/2" trap to drain and overow. Before proceeding, make nal operational check
by lling tub with water to overow and operate pump for 30 minutes. Check for leaks carefully both
while pump is running and while turned off. Allow water to stand in tub for at least 30 minutes before
draining. HYDRO MASSAGE PRODUCTS WILL NOT BE RESPONSIBLE FOR WATER DAMAGE
OF ANY KIND IN CONNECTION WITH ONE OF OUR WHIRLPOOL BATHS.
When selecting ll spout location, check to ensure that the spout is long enough to clear the tub rim
from its desired location. If installation is to be on the tub deck, check the backside of the tub for
adequate space for connection to water lines before drilling or cutting tub.
WARNING: HEATER AND ELECTRICAL INSTALL: A service access panel of minimum of an 18"
square must be provided adjacent to heater/pump assembly.