Installation Instructions

23
Hydro Massage Products LLC • 303-341-1845 | FAX: [phone] • www.hydromassageproducts.com • [e-mail]
Your blower is equipped with an
integrated air heating element,
built in electronic control,
variable speeds, pulsation
cycle, a 20 minute timer and an
automatic drying cycle, which
will activate approximately 20
minutes after the blower has
been turned off.
OPERATING INSTRUCTIONS
For Platinum Combination Series
NOTE: Do not start pump until all jets are submerged water level should be 3" above highest jet.
DUAL ON/OFF AIR BUTTON CONTROL Operates each pump/jet
action independently. Press the button once and the pump will turn on.
Press the button again and the pump will turn off.
THREE SPEED PUMP CONTROL:
To operate the 3 speed control, turn the dial to change the speed.
H(High) to M(Medium) to L (Low)
NECK MASSAGE PILLOW
Turning the dial counter-clockwise will open the Neck Massage Pillow
pressure to 100%. Turning the dial clock wise will reduce the pressure
down to 5%.
NOTE: Before operating the Neck Massage Pillow, make sure the
Lycra pillow cover is covering the grey pillow and the pillow is seated
securely in the grommets.
ELECTRONIC BLOWER CONTROL:
#1. 1st press: The blower starts at maximum speed,
LED: ON
2nd press: The blower stops, LED: ON until the
purge cycle stops. Approximately 20
minutes.
#2. 1st press: Speed goes up, LED ON when
pressing release pressure at the
desired speed
#3. 1st press: Speed goes down, LED: ON when
pressing release pressure at the
desired speed
#4. 1st press: Slow pulsation cycle ON, LED: ON
2nd press: Quick pulsation cycle OFF, LED: ashes
3rd press: Pulsation cycle OFF, LED: OFF
Neck Massage Pillow
with Cover