Installation Instructions

25
Hydro Massage Products LLC • 303-341-1845 | FAX: [phone] • www.hydromassageproducts.com • [e-mail]
HYDROCLEAN SANITATION SYSTEM
1. This unit meets the requirements of NSF Protocol P308 ozone sanitation systems for jetted bathtubs
and pedicure foot-baths.
2. The Hydroclean will operate automatically whenever the pump is running. You will notice a slight sweet
smell and bubbles will be coming out of the dedicated Hydroclean jet on the side wall of the tub about 1
1/2 “ in diameter.
3. No maintenance or cleaning of the unit is required. The life of the unit is approximately 9000 hrs of use.
HYDRO SCENTS AROMATHERAPY
The entire bag of beads should be put in the canister. Never
put beads in separately in the canister. Always leave the
beads in the bag.
The beads do not breakdown or dissolve. The fragrance just
dissipates over time. Once the fragrance is gone, remove the
bag of beads and replace.
INLINE MAINTENANCE HEATER
The whirlpool heater is totally self-contained to insure trouble free operation. Once the whirlpool heater
is plugged in, operation is automatic. The heater will maintain the temperature of the water in the bath
tub. As with all electrical devices, certain safety precautions should be taken during use. Please read
Safety Instructions on Page 1 of this Manual.
Features of the Inline Heater:
Hi-Limit: Some whirlpool heaters include an exclusive “Smart Hi-Limit”. This Hi-limit will not “false trip”
from hot tap water. It will only turn the heater off if the thermostat fails. To reset, simply press the red
button located on the heater. If the Hi-limit trips frequently, call the factory.
Safety features: In addition to the thermostat and Hi-limit, the whirlpool heater is equipped with a built in
pressure switch. This switch will not allow the heater to turn on if the pump is not running.
CAUTION: Before use of the pump and heater, test the GFCI for proper operation. The pump and
heater should turn off when the GFCI “TEST” button is pushed. Note: the heater will only operate if the
pump is running.
WARNING...Prolonged immersion in hot water may induce extremely high body temperature
(hyperthermia). Hyperthermia occurs when the internal temperature of the body reaches a level
several degrees above the normal body temperature of 98.6º F. The symptoms of hyperthermia include
an increase in the internal temperature of the body, dizziness, lethargy, drowsiness and fainting.
Symptoms of Hyperthermia include:
1. Failure to perceive heat
2. Failure to recognize the need to exit the tub
3. Unawareness of impending hazard
4. Fetal damage in pregnant women
5. Physical inability to exit the tub, and
6. Unconsciousness resulting in the danger of drowning
WARNING: The use of alcohol, drugs, or medication can greatly increase the risk of fatal
hyperthermia.