Installation Instructions

INSTALLATION AND OPERATION GUIDELINES
Read all instructions before installing tub. Installer / product owner is responsible for complying with all state and local codes.
Warranty coverage will be void if unit is not tested and installed per the enclosed instructions. Hydro Massage strongly recommends
using licensed professionals to install this product. Warning: Certain cleaning products will permanently damage the acrylic surface.
Read product label carefully before using any cleaning products. Never use anything abrasive, aerosol sprays or any product that is
described as “scrubbing bubbles".
BEFORE INSTALLING:
Inspect tub thoroughly
1. Damage from shipping or delivery must be reported to carrier immediately. Do not install damaged tub. Hydro Massage
Products is not responsible for damage occurring in transit.
2. Factory defect must be reported to factory before tub is installed. Defects or damage claimed after installation will be excluded
from warranty.
3. Important – Measure tub on site carefully. Specications are subject to change without notice. Hydro Massage Products is NOT
responsible for any preparatory labor or materials.
ATTENTION INSTALLER!
THIS TUB MUST BE TESTED FOR OPERATION AND LEAKS PRIOR TO ENCLOSURE OF SURROUNDING AREAS. FAILURE TO
DO SO WILL VOID WARRANTY. THIS TUB WAS WATER TESTED AT THE FACTORY AND FOUND TO BE FULLY OPERATIONAL
AND LEAK-FREE PRIOR TO SHIPPING. FREIGHT, HANDLING AND JOB SITE EXPOSURE MAY HAVE DETERIORATED
THE TUB’S CONDITION. IT IS THE RESPONSIBILITY OF THE INSTALLER TO THOROUGHLY TEST THE UNIT PRIOR TO
INSTALLATION. TUBS ARE INTENDED FOR INDOOR USE ONLY. TUBS ARE WARRANTED FOR INDOOR INSTALLATION IN A
CLIMATE CONTROLLED ENVIRONMENT ONLY.
TEST PROCEDURES
1. Place the tub on a at surface such as a driveway.
2. Seal the drain with tape.
3. Fill tub to overow and allow tub to stand for ve minutes without any components running. NOTE: the overow is a plumbing
device designed to prevent water from reaching a certain level in your tub. DO NOT, under any circumstances, tape off or block
the overow in any way. Any controls located above the normal water line are designed to be water-resistant, not water-proof.
The controls will not leak under normal usage, however, they are not warranted against leaks when improperly used or subjected
to conditions for which they were not designed.
4. Plug the components into a 110v GFCI outlet. Start the equipment and check for leaks by examining the area underneath and
surrounding the tub.
5. Check that all optional equipment is functioning properly and that the features on the tub match exactly what was ordered.
6. If any leaks or operating problems are discovered, do not complete installation until problems are resolved. Hydro Massage
Products will not be responsible for leaks claimed after the tub is installed, or any costs involved with removing or reinstalling the
tub or the costs of any surrounding materials or labor.
7. Do not put blow-in or berglass insulation around or near the motors. Doing so will void the warranty.
Always protect tub from construction damage by using a protective cover. Damage, including chips and scratches, incurred at the job-
site is excluded from warranty, but may be repaired by qualied technician at the owner’s expense. Do not stand in the tub or store
materials in the tub during construction. Proper waste and overow installation is the responsibility of the installer. Hydro Massage
Products does not warrant leaks associated with improper waste and overow installation.
ATTENTION INSTALLER!
Access must be provided to all electrical components. The access panel(s) must have a minimum size of 18" x 18" for installation and
future servicing of the equipment.
Hydro Massage Products will not authorize any service unless clear access is available. Access from a crawlspace or incomplete
access to all equipment may result in warranty claims being denied.