Installation Instructions

Hydro Massage Products LLC • 303-341-1845 | FAX: [phone] • www.hydromassageproducts.com • [e-mail]
26
OPERATING INSTRUCTIONS
Mood Light & Chromatherapy
MOOD LIGHT: Press the on/off button once to turn on light; Press it again to turn off. Mood
light comes with 1 red and 1 blue colored lens cover.
CHROMATHERAPY: Use the on/off button for the following sequence:
1
st
press starts slow transition through all colors 2
nd
press turns off
3
rd
press is all colors on 4
th
press turns off
5
th
press is BLUE and GREEN 6
th
press turns off
7
th
press is BLUE and RED 8
th
press turns off
9
th
press is BLUE 10
th
press turns off
11
th
press is RED and GREEN 12
th
press turns off
13
th
press is GREEN 14
th
press turns off
15
th
press is RED 16
th
press turns off
17
th
press is slow icker of above sequence 18
th
press turns off
19
th
press is fast icker of all colors 20
th
press turns off
21
st
press starts cycle over.
If light is off for more than (approximately) 3 seconds, the sequence starts over.
RE-LAMPING INSTRUCTIONS
1. Disconnect the power to the bathtub.
2. Drain the bathtub.
3. To remove lens, position the wrench over the light in such a way that
both the wall tting and the lens splines engage.
4. While rmly holding the outer ring of the wrench and free of rotation,
turn the center part of the tool counter-clockwise to unscrew the
lens.
5. Replace Mood Light bulb with type 912 bulb only. (Contact factory
to purchase replacement Chromatherapy bulb)
6. Do not twist bulb into socket! Use gentle pressure and push bulb
into place.
7. Inspect o-ring to make sure that it is clean and free of damage and
is properly positioned in the o-ring groove before replacing lens.
Note: If a replacement o-ring is necessary or lens does not seal
properly, do not ll bathtub. Contact Factory immediately.
8. To replace lens, gently screw the lens into the wall tting nger tight.
9. Position the wrench over the light so that both the wall tting and the
lens splines engage.
10. While rmly holding the outer ring of the wrench and free of rotation,
turn the center part of the tool clockwise until rotation comes to a
stop. Do not over tighten!
Light Lens, bulb
and 'O' ring.
Chromatherapy
bulb shown