Technical Specifications

TECHNICAL SPECIFICATIONS
Drain End drain
Pump Location(s): Select 1 Std. = Standard / Alt LF/RF Optional
Bath Weight (empty) 155 lbs
Gallons to Operate 38-56
A
Jet &
Control
placement
may vary
1”
1”
.75”
1.25”
Front
Skirt
32"
115º
14.5"
9"
Backrest angle
NOTE:
Graphics may not be to scale. Specications and features are subject to change without notice and are ± .25”. All nal measurements should be taken
from tub on site. Access 18”x 18” or larger is required for each pump. Some pump locations and plumbing may extend beyond the perimeter of the bath.
Hydromassage Products LLC • 303-341-1845 | FAX: [phone] • www.hydromassageproducts.com
X HTT® Leg Therapy Air Massage System includes 10 Air Jets on the
oor. Optional on Combo Plat and Combo Gold Series
X 6 Jet HTT® Back Massage System: N/A on Combo Series-Standard
on Plat series
Warm Back Tubing Zone
A
B
C
BATHERS: 1
INSTALLATION
DECK (D)
UNDER MOUNT (U)
• ALCOVE (A)
FREESTANDING (F)
CLAWFOOT (L)
PEDESTAL (P)
Skirt & Tile Flange
- Integral skirt with
velcro access
panel
raised headrest
lip prole
radius corner
lip prole
20"
22"
EZ Clean
Tile Flange
ELECTRICAL SPECIFICATIONS
Motor/Pump (1) 115v 20AMP GFCI Circuits
Bath includes EZ Level Legs
Mystique MYAS6032SKTF 60" x 32" x 22"
PRODUCT NUMBER: MYAS6032SKTF-LH & MYAS6032SKTF-RH
AIR SILVER SERIES
STANDARD FEATURES & ACCESSORIES for AIR SILVER SERIES BATHS ______
OPTIONAL FEATURES & ACCESSORIES
(Please type in the box below)
JETS
12 Classic Air Jets Sidewall
PUMPS
1.0 Air Power 3-Speed Warm Air Pump
Quiet Pad Anti-Vibration Mounted Pump
CONTROLS
Air Switch On/Off Control(s)
Automatic Purge & Dry Cycle Control
PURITY
HydroCleanse
STANDARD ACCESSORIES
EZ Level Adjustable Legs
FDA Recipe Non-Toxic Food & Beverage Grade
Plumbing (primarily)
30 Point Quality Assurance Factory Test
Adjustable Leveling legs
Integral Tile Flange
REQUIREMENTS
Pump Locations: Select 1
Electrical: one 115v GFCI Circuit
Tub should not be supported by the lip in any way. Level tub &
screw or glue EZ Level adjustable legs to sub oor.
CUT OUT DIMENSIONS:
OVALS: A template will be provided
RECTANGLES: Subtract 1” to 1.5” from length & width for hole
cut out size
EZ CLEAN CAST ACRYLIC
LIMITED LIFETIME WARRANTY
ANSI