Installation Instructions

Hydro Massage Products LLC • 303-341-1845 | FAX: [phone] • www.hydromassageproducts.com • [e-mail]
22
OPERATING INSTRUCTIONS
For Gold Combination Systems
NOTE: Do not start pump until all jets are submerged; water level should be 3" above highest jet.
ON/OFF AIR BUTTON PUMP CONTROL: Press the button once
and the pump will turn on. Press the button again and the pump will
turn off.
THREE SPEED PUMP CONTROL: To operate the 3 speed control,
turn the dial to change the speed. H(High) to M(Medium) to L (Low)
ELECTRONIC BLOWER CONTROL:
#1. 1st press: The blower starts at maximum speed,
LED: ON
2nd press: The blower stops, LED: ON until the
purge cycle stops. Approximately 20
minutes.
#2. 1st press: Speed goes up, LED ON when
pressing release pressure at the
desired speed
#3. 1st press: Speed goes down, LED: ON when
pressing release pressure at the
desired speed
#4. 1st press: Slow pulsation cycle ON, LED: ON
2nd press: Quick pulsation cycle OFF, LED: ashes
3rd press: Pulsation cycle OFF, LED: OFF
MICROFLOW, ULTRA FLOW AND SOLE SOOTHER JET
PRESSURE ADJUSTMENT: Turning the jet face clockwise will
reduce the pressure up to 95% off.
CHROMATHERAPY LIGHT ON/OFF AIR BUTTON: Press the
button once and light turns on. Press the button again and the light
turns off. See page 26 for color sequence.
BULB REPLACEMENT: See page 26 for bulb replacement and
lens instructions.
HYDROCLEAN SANITATION SYSTEM: See page 25 for operating instructions.
INLINE MAINTENANCE HEATER CONTROL: See page 25 for operating instructions.
Your blower is equipped with an
integrated air heating element,
built in electronic control,
variable speeds, pulsation
cycle, a 20 minute timer and an
automatic drying cycle, which
will activate approximately 20
minutes after the blower has
been turned off.
Outer Ring-Turn On & OFF