Installation Instructions

3
Hydro Massage Products LLC • 303-341-1845 | FAX: [phone] • www.hydromassageproducts.com • [e-mail]
INSTALLATION INSTRUCTIONS
Continued
WARNING: Whirlpool pump and piping are factory assembled. Relocation of pump or other
modications could adversely affect the performance and safe operation of this whirlpool. Hydro
Massage Products shall not be liable under its warranty or otherwise for personal injury or damage
caused by such unauthorized modication.
QUIETNESS OF OPERATION—Hydro Massage Products has engineered their whirlpool baths from
the base to the lip to ensure quality, value, functional design and maximum bathing comfort. However
installations are accountable for as much as 50% of a tub’s operating quietness. Please ensure the
following:
Verify the oor structure is adequate to support the whirlpool with bather(s). Insulate the tub surround
and leave a dead air space around the pump and tub. Leave 1/8" to 3/16" gap between tub lip and
surround.
WARNING...Refer all plumbing or electrical repair to a qualied service technician. DO NOT
ATTEMPT TO RESOLVE THE PROBLEM. Attempts to repair plumbing or electrical equipment by a
non-qualied service technician can result in danger of electrical shock or damage to the unit. Call your
dealer for the name of the qualied service technician near you.
The user should do no servicing of this product. There are no user serviceable parts. All controls and
air switches are located on the deck of the tub. These are the only controls that should be used by
the consumer. Do not change or alter any of these controls under any circumstances. Motors are
self-lubricating and no lubrication is required. This unit should only be serviced by a qualied service
representative.