Operation Manual
Table Of Contents
- Installation and connection
- 3.1 Notes
- 10. Warranty and returns
- 10.1 Warranty
- 10. Garantie et renvoi
- 3. Installatie en aansluiting
- 10. Garantie en terugzending
- 3. Installation und Anschluss
- 10. Gewährleistung und RMA (Warenrücksendegenehmig
- 3. Montaż i podłączenie
- 10. Gwarancja i zwrot
- 3. Installation og tilslutning
- (2) Rens dine puljer og filtrering system regelmæs
- (3) Du skal udlede vandet fra bunden af vandpumpen
- (4) I en anden måde, bør du tjekke enheden er vand
- (5) Efter at enheden er betinget for vintersæsonen
- (6) Når enheden kører, er der hele tiden en smule
- 10. Warranty and returns
- 10.1 Warranty
- 14 -
difference between the water temperature in the pool and the temperature of the soil surrounding the pipe. This
increases the operating time by 3% to 5%.
3.4 Check-valve installation
Note: If automatic dosing equipment for chlorine and acidity (pH) is used, it is essential to protect the heat pump
against excessively high chemical concentrations which may corrode the heat exchanger. For this reason, equipment
of this sort must always be fitted in the piping on the downstream side of the heat pump, and it is recommended to
install a check-valve to prevent reverse flow in the absence of water circulation.
Damage to the heat pump caused by failure to observe this instruction is not covered by the warranty.
3.5 Typical arrangement