Operation Manual
Table Of Contents
- Installation and connection
- 3.1 Notes
- 10. Warranty and returns
- 10.1 Warranty
- 10. Garantie et renvoi
- 3. Installatie en aansluiting
- 10. Garantie en terugzending
- 3. Installation und Anschluss
- 10. Gewährleistung und RMA (Warenrücksendegenehmig
- 3. Montaż i podłączenie
- 10. Gwarancja i zwrot
- 3. Installation og tilslutning
- (2) Rens dine puljer og filtrering system regelmæs
- (3) Du skal udlede vandet fra bunden af vandpumpen
- (4) I en anden måde, bør du tjekke enheden er vand
- (5) Efter at enheden er betinget for vintersæsonen
- (6) Når enheden kører, er der hele tiden en smule
- 10. Warranty and returns
- 10.1 Warranty
- 16 -
2. Connect power to the heat pump and press the On/Off button on the electronic control panel. The unit will
start up after the time delay expires .
3. After a few minutes, check whether the air blowing out of the unit is cooler.
4. When turn off the filter pump , the unit should also turn off automatically , if not, then adjust the flow switch.
Depending on the initial temperature of the water in the swimming pool and the air temperature, it may take
several days to heat the water to the desired temperature. A good swimming pool cover can dramatically reduce
the required length of time.
Water Flow Switch:
It is equipped with a flow switch for protecting the HP unit running with adequate water flow rate .It will turn on wh
en the pool pump runs and shut it off when the pump shuts off. If the pool water level higher than 1 m above or b
elow the heat pump’s automatic adjustment knob, your dealer may need to adjust its initial startup.
Time delay - The heat pump has a built-in 3-minute start-up delay to protect the circuitry and avoid excessive
contact wear. The unit will restart automatically after this time delay expires. Even a brief power interruption will
trigger this time delay and prevent the unit from restarting immediately. Additional power interruptions during this
delay period do not affect the 3-minute duration of the delay.
3.9 Condensation
The air drawn into the heat pump is strongly cooled by the operation of the heat pump for heating the pool water,
which may cause condensation on the fins of the evaporator. The amount of condensation may be as much as
several litres per hour at high relative humidity. This is sometimes mistakenly regarded as a water leak.
3.10 Operating modes for optimal use
- POWER: Used primarily at the beginning of the season because this mode allows very rapid temperature rise
- SMART: The heat pump has completed its primary task, in this mode; the heat pump is in a position to maintain
the pool water in an energy efficient manner. By automatically adjusting speed of compressor and fan the heat
pump delivers a better return.
- SILENT: In the summer months when the heat output is minimal required, the heat pump in this mode is even
more profitable. Added benefit; when the heat pump heats. It goes with minimal noise load.