Operation Manual
Table Of Contents
- Installation and connection
- 3.1 Notes
- 10. Warranty and returns
- 10.1 Warranty
- 10. Garantie et renvoi
- 3. Installatie en aansluiting
- 10. Garantie en terugzending
- 3. Installation und Anschluss
- 10. Gewährleistung und RMA (Warenrücksendegenehmig
- 3. Montaż i podłączenie
- 10. Gwarancja i zwrot
- 3. Installation og tilslutning
- (2) Rens dine puljer og filtrering system regelmæs
- (3) Du skal udlede vandet fra bunden af vandpumpen
- (4) I en anden måde, bør du tjekke enheden er vand
- (5) Efter at enheden er betinget for vintersæsonen
- (6) Når enheden kører, er der hele tiden en smule
- 10. Warranty and returns
- 10.1 Warranty
- 18 -
Draining jet
1. Install the draining jet under the
bottom panel
2. Connect with a water pipe to drain out
the water.
Note: Lift the heat pump to install the
jet. Never overturn the heat pump, it
could damage the compressor.
Water Inlet & outlet junction
1. Use the pipe tape to connect the
water Inlet & outlet junction onto the
heat pump
2. Install the two joints like the picture
shows
3. Screw them onto the water Inlet &
outlet junction
Cable wiring
1. Connect the power supply wire
through the white hole like the picture
shows.
2. Fix the other side on joints inside the
electric box.
Water pump wiring
1. Connect the water pump wire through
the white hole marked
2. Fix the other side on joints inside the
electric box.