Installation Instructions

31
OPERATING SAFETY
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: If you do not follow these instructions exactly, a re or explosion may result
causing property damage, personal injury or loss of life.
1. The micro boiler does not have a pilot. It is equipped with an ignition device that automatically
lights the burner. Do NOT try to light the burner by hand.
2. Before operating smell all around the micro boiler area for evidence of leaking gas. Be sure to
smell next to the oor because some gas is heavier than air and will settle on the oor.
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone.
• Follow the gas suppliers instructions. If gas supplier cannot be reached, call re dept.
3. Use only your hand to turn the gas shutoff valve. Never use tools. If the valve will not turn by hand,
don’t try to repair it, call a qualied service technician. Force or attempted repair may result in a
re or explosion.
4. Do not use this micro boiler if any part has been under water. Immediately call a qualied service
technician to inspect the micro boiler and to replace the unit if needed.
OPERATING INSTRUCTIONS
1. STOP! Read the safety information above or in the Owner’s Manual.
2. Turn off all electric power to the micro boiler.
3. Do not attempt to light the burner by hand.
4. Turn the manual as valve located on the outside of the unit clockwise to the OFF position.
5. Wait ve (5) minutes to clear out any gas. If you then smell gas, STOP! Follow “B” in the safety
information above on this label. If you don’t smell gas, go to next step.
6. Turn the manual gas valve located on the outside of the unit counterclockwise to the ON position.
7. Turn on all electrical power to the micro boiler.
8. If the micro boiler will not operate, follow the instructions “To turn off Gas to appliance” and call
your service technician or gas supplier.
TO TURN OFF GAS TO APPLIANCE
1. Turn off all electric power to the micro boiler if service is to be performed.
2. Turn the manual gas valve located on the outside of the unit clockwise to the OFF position.