Installation Instructions

33
NORMAL OPERATION
TEMPERATURE CONTROLLER AND REMOVE CONTROLLER
The illustration below shows an example of the controllers. The exact display may differ from examples.
GENERAL
• Flow rate to active micro boiler: 0.5 gallon per minute at the default set
temperature
• Flow rate to keep the micro boiler running: 0.4 gallon per minute.
• The controllers have an energy saving mode. Five minutes after the micro
boiler stops operating, the back-light of the controllers turn off.
• The back-light of the controllers will turn back on once the micro boiler be-
gins ring again.
STAND BY LED (Orange)
"HOT" Buon
"COLD" Buon
Press the "HOT" buon or the "COLD"
buon to set the hot water temperature.
IN USE LED (Green)
The indicator is ON to show that
power is ON.
The indicator lights during combuson.
"INFO" Buon
Inlet water
Each me the buon is pressed,
the operaon mode is selected
in the sequence of the following.
temperature
Outlet water
temperature
Water
flow
Built-in controller
Display for Temperature
When the STAND BY LED is ON, the
hot water temperature will be
displayed.
"ON/OFF" Buon
Remote controller
Press this buon to
start or stop operaon.
NOTICE
• When the remote controller is installed it will take priority over the built-in controller.
• The controller has an energy saving mode. Five minutes aer the water heater stops
operang, the backlight of the controller turns off.
• The backlight of the remote will turn back on once the water heater begins firing again.
Temperature Controller
NOTICE