Installation Guide

3
PREPARE TAIL PIECE
Drain waste vent must always be installed according to
local standard. Verify the placement of the bathtub before
drilling the hole for the drain waste vent.
Install 1 ½"rubber slip gasket over the drain body.
Thread in shoe.
Glue shoe to tail piece.
10
12
13
11
FIGURE 5
tail piece (shoe)
INSTALL DRAIN HARDWARE
Apply plumbers putty around the Drain Body and pass it
thrugh the drain hole (Figure 3).
Apply rubber gasket and slide it over the
bottom of the Drain Body (Figure 3)
Slide the rubber washer over the drain body.
Attach the drain Body to the ABS/ PVC Shoe fitting and
tighten until the Gasket has created a seal with the bottom
of the bathtub. DO NOT OVERTIGHTEN (Figure 4).
6
7
8
9
FIGURE 3
FIGURE 4
FIGURE 5