Installation Guide

– 7 –
ELECTRONIC SOFT TOUCH CONTROL - This is the on/off control switch for the whirlpool system. It bears the
Hydro Systems logo. Press the logo once to turn the whirlpool system on. Press it again to turn the whirlpool system off.
The whirlpool system is congured to run for thirty minutes and shut down automatically. If a longer bathing period is
desired, press the logo to start it again. The whirlpool system will not turn on until the jets are covered with water.
If you don’t push the button the pump will automatically slow down and switch to “pulse” mode. You can switch to pulse
mode at any R.P.M. by pressing the button a third time. To turn the pump off, push the button a forth time.
WHIRLPOOL JETS - These are fully adjustable and directional. To adjust the ow of water coming from the jets, rotate
the escutcheon. Clockwise will reduce ow, counter clockwise will increase ow. To adjust the direction of the jets, point
the eyeball in the desired direction.
ANTI-VORTEX SAFETY SUCTION - This is the intake where water is drawn in for the pump. Do not operate the
whirlpool system without the suction cover in place.
USER CARE AND MAINTENANCE
WARNING: Any service or maintenance other then described below should be performed by a qualied service
representative. Call your Hydro Systems dealer for the name of a qualied service representative near you.
To maintain the “like new” look of your Hydro Systems acrylic or gelcoat bathtub, we recommend the following easy care
procedures.
•
Never use abrasive cleaners
•
Use common household, non-abrasive cleaners for most cleaning jobs such as Lysol Basin, Tub & Tile Cleaner®,
Glass Plus®, Simple Green®, Mr. Clean, and Top Job, or a mild dishwashing detergent such as Ivory® Liquid. Follow
the manufacturers’ directions and precausions. Rinse well and dry with a clean cloth.
•
Do not use products such as acetone (nail polish remover), dry cleaning solution, lacquer thinners, gasoline, pine oil,
wintergreen, etc.
•
Use Isopropyl rubbing alcohol to clean grease oil, paint or ink. Dry with a clean soft cloth.
•
Avoid using razor blades, putty knives, or other metal instruments that might scratch the surface. Small scratches can
be removed by applying a thin coat of automotive paste wax and bufng lightly with a clean cloth. For deeper scratches,
sand the surface lightly with 600 grit “wet or dry” sand paper, rub out with ne bufng compound, and apply a coat of wax.
WARNING: Flush the whirlpool system periodically (at least every 90 days) as follows: Fill the bathtub with water, add
1/2 cup of household bleach, run the whirlpool system for 10 minutes, drain completely. Rinse the bathtub and rell with
water, run the whirlpool system for 5 minutes, drain completely. Wipe dry with a soft cloth.