User's Manual

5.OO setup (continued)

5.O2 GUIDED SETUP (continued)

Sanitizer (3-Product Models Only)

1) To set up the sanitizer dispensing parameters for a unit

operating in Probe Mode on a Door Machine, scroll to the

top and select the Sanitizer Pump.

2) Next, enter the following:

Sanitizer Pump Speed (5-55 RPM): This is the speed that

the pump will run at whenever the rinse signal is active.

Accepting the Guided Setup

To complete the Guided Setup or complete changes made to

a prior setup, scroll to the bottom and press Apply.

Probe Mode on a Conveyor Machine

To configure a DMx unit that utilizes a conductivity probe on a

Conveyor Machine, start on the Guided Setup Screen.

1) Confirm that the blue button is set to Probe and select

Conveyor as the Machine Type.

2) When this is done, the user will be prompted to enter the

Conveyor Rack Time (in seconds). This setting helps the

dispenser count racks in Conveyor Mode.

• The field can be set from 0-90 seconds.

• Whereas Door Mode counts a rack every time the

detergent and rinse signals are cycled, in Conveyor Mode,

a rack is counted when the rinse signal is on continuously

for the configured Conveyor Rack Time.

• If you are unsure about what to enter as the Conveyor

Rack Time, you can measure the amount of time it takes

for a rack of dishes to pass through the rinse portion of the

conveyor.

Detergent

Probeless Autoswitch (Conveyor)

Probeless Autoswitch is a feature that, when enabled, automatically switches the unit into Probeless mode if problems are

detected with the probe readings.

More specifically, if the probe reading is zero (0) or greater than ninety (90) for a configured number of racks (enter in the field

titled “Trigger After”) it will trigger the unit to switch to Probeless mode without interrupting the operation.

Probe Mode on a Conveyor Machine

Press

Apply

Sanitizer

Settings