User's Manual

5.OO setup (continued)

5.O3 GUIDED SETUP - Probeless Mode

From the first Guided Setup screen, the user can change the dispenser into Probeless Mode by pressing the gray button

labeled “Change Probe Configuration” and selecting “No”. The user can also select whether a temperature sensor is being

used in the wash tank and the machine type at this time.

If a user is operating in Probeless or Time Mode to dispense detergent, there are three possibilities for machine type that will

be explained in greater detail:

• Probeless Mode, Door Machine

• Probeless Mode, Conveyor Machine

• Probeless Mode, Alternate (Alt) Door Machine

Probeless Mode on a Door Machine

Detergent

In Probeless mode for a door machine, the dispensing of

detergent is configured for set amounts of time depending on

whether an initial charge or incremental dose is triggered.

Initial Charge (0-200s): An initial charge is meant to be

dispensed every time the tank is drained and refilled with fresh

water. In Probeless, Door Mode, it is triggered when a Rinse

signal is received that is not preceded by a Detergent signal

within 90 seconds.

Incremental Dose (0-20s): An incremental dose in Probeless,

Door Mode is dispensed each rack when the detergent signal

is triggered on for the 3 second signal acceptance time. When

this occurs, the incremental dose will dispense and the pump

will stop. To trigger another incremental dose, the rinse signal

needs to cycle on/off to count the current rack and then a new

detergent signal would need to be received.

Detergent

Settings