User's Manual

5.OO setup (continued)

5.O3 GUIDED SETUP - Probeless Mode (continued)

Probeless Mode on a Conveyor Machine (continued)

Rinse

1) To set up the rinse dispensing parameters for a unit

operating in Probeless Mode on a Conveyor Machine,

scroll to the top and select the Rinse Pump.

2) Next, enter the following:

• Rinse Aid Pump Speed (5-55 RPM): This is the speed

that the pump will run at whenever the rinse signal is active.

• Rinse Aid Feed Option:

• Rinse on Rinse- The rinse pump will run whenever the

rinse signal is active as per the above configuration

parameters.

NOTE: There is no Rinse Pump Delay in Conveyor Mode.

NOTE: There is no Rinse on Detergent setting in Conveyor

Mode.

Sanitizer (3-Product Models Only)

1) To set up the sanitizer dispensing parameters for a unit

operating in Probeless Mode on a Conveyor Machine,

scroll to the top and select the Sanitizer Pump.

2) Next, enter the following:

Sanitizer Pump Speed (5-55 RPM): This is the speed that

the pump will run at whenever the rinse signal is active.

Calibrate Pump / Solenoid

Pump or solenoid calibration for Probeless Conveyor Mode is

done identically to the process described starting on page 27.

When all settings for Detergent and Rinse have been set, press

Apply to complete the Guided Setup.

Select

Rinse

Pump

Rinse Pump

Speed

Rinse Feed

Option

Press

Apply

Probeless Mode on a Conveyor Machine

Sanitizer

Settings