Installation Guide
– 7 –
WHIRLPOOL JETS - These have fully adjustable direction. By rotating the jet escutcheon, this will open/close the
ow of water to that jet, point the eyeball in the desired direction.
ANTI-VORTEX SAFETY SUCTION - This is the intake where water is drawn in for the pump. Do not operate
the
whirlpool system without the suction cover in place.
USER CARE AND MAINTENANCE
WARNING: Any service or maintenance other then described below should be performed by a qualied
service representative. Call your Hydro Systems dealer for the name of a qualied service representative
near you.
To maintain the “like new” look of your Hydro Systems acrylic or gelcoat bathtub, we recommend the following easy
care procedures.
•
Never use abrasive cleaners
•
Use common household, non-abrasive cleaners for most cleaning jobs such as Lysol Basin, Tub & Tile Cleaner®,
Glass Plus®, Simple Green®, Mr. Clean, and Top Job, or a mild dishwashing detergent such as Ivory® Liquid.
Follow the manufacturers’ directions and precausions. Rinse well and dry with a clean cloth.
•
Do not use products such as acetone (nail polish remover), dry cleaning solution, lacquer thinners, gasoline, pine
oil, wintergreen, etc.
•
Use Isopropyl rubbing alcohol to clean grease oil glue, paint or ink. Dry with a clean soft cloth.
•
Avoid using razor blades, putty knives, or other metal instruments that might scratch the surface. Small scratches
can be removed by applying a thin coat of automotive paste wax and bufng lightly with a clean cloth. For deeper
scratches, sand the surface lightly with 600 grit “wet or dry” sand paper, rub out with ne bufng compound, and
apply a coat of wax.
Flush the whirlpool system periodically (at least every 90 days) as follows: Fill the bathtub with water, add 1/2 cup of
household bleach, run the whirlpool system for 10 minutes, drain completely. Rinse the bathtub and rell with water,
run the whirlpool system for 5 minutes, drain completely. Wipe dry with a soft cloth.