Installation Sheet

WARNING: When using your Hydro Systems whirlpool tub, basic precautions should be followed.
READ AND FOLLOW ALL INSTRUCTIONS.
1. DANGER: To reduce the risk of injury, do not permit children to use this unit unless they are closely supervised
at all times.
2. Use this unit only for its intended use as described in this manual. Do not use attachments not recommended
by the manufacturer.
3. Never drop or insert any object into any opening.
4. Do not operate this unit without suction cover installed.
5. The unit must be connected only to a dedicated electrical supply circuit that is protected by a Ground Fault
Circuit Interrupter (GFCI). The GFCI must be provided by the installer and should be tested on a routine basis by
the homeowner. To test the GFCI push the test button. The GFCI should interrupt power. Push the RESET button.
Power should be restored. If the GFCI fails to operate in this manner there is a ground current fault, indicating
the possibility of an electric shock. Do not use the tub. Disconnect the power and have the problem corrected by
a qualified service representative. Re-test the GFCI and only when it is operating properly may the whirlpool tu
be used.
6. A terminal is provided on the exterior of most equipment. To reduce the risk of electric shock, connect this terminal
to the grounding terminal of your electric service or supply panel with a conductor equivalent in size to the circuit
conductors supplying this equipment.
Save These Instructions
4. READ ALL THE INSTRUCTIONS before you begin the installation.
5. INSPECT THE TUB before you begin the installation. Inspect the following:
•
Is it the correct model? The corect size? The correct color?
•
If options or upgrades were ordered, are they complete and correct?
•
If the tub was ordered with components in non-standard locations, check to make sure they all are in their correct
locations.
•
Check all components to make sure no damage occurred during shipping.
•
For Tubs with Tile Flange inspect for positive draft to bathing well
DO NOT INSTALL THE TUB if any of the above is not correct.
Contact the dealer where the bathtub was purchased or call Hydro Systems directly at 661-775-0686.
– 2 –
You will need to know the bathtub serial number attached to your warranty card
and also located on the back side of the bathtub when contacting Hydro Systems.
WARNING: This product can expose you to chemicals including styrene, which is known to the State of California to
cause cancer. For more information, go to www.P65Warnings.ca.gov.
1. DANGER: RISK OF ELECTRICAL
SHOCK. Connect only to a circuit protected by a ground fault circuit
interrupter.
2. This unit should be installed by a qualified service representative. All electrical connections should be made by a
licensed electrician. Grounding is required.
3. The installa
t
ion of Hydro Systems bathtubs must meet all applicable codes and regulations.
INSTALLATION INSTRUCTIONS