Installation Sheet

– 7 –
ELECTRONIC SOFT TOUCH CONTROL - This is the on/off control switch for the whirlpool system. It bears the
Hydro Systems logo. Press the logo once to turn the whirlpool system on. Press it again to turn the whirlpool system off.
The whirlpool system is configured to run for thirty minutes and shut down automatically. If a longer bathing period is
desired, press the logo to start it again. The whirlpool system will not turn on until the jets are covered with water, if you
have optional water level protection.
WHIRLPOOL JETS - These are fully adjustable and directional. To adjust the flow of water coming from the jets,
rotate the escutcheon. Clockwise will reduce flow, counter clockwise will increase flow. To adjust the direction of the jets,
point the eyeball in the desired direction.
ANTI-VORTEX SAFETY SUCTION - This is the intake where water is drawn in for the pump. Do not operate the
whirlpool system without the suction cover in place.
USER CARE AND MAINTENANCE
WARNING: Any service or maintenance other then described below should be performed by a qualified service
representative. Call your Hydro Systems dealer for the name of a qualified service representative near you.
To maintain the “like new” look of your Hydro Systems acrylic or gelcoat bathtub, we recommend the following easy care
procedures.
•
Never use abrasive cleaners
•
Use common household, non-abrasive cleaners for most cleaning jobs such as Lysol Basin, Tub & Tile Cleaner®,
Glass Plus®, Simple Green®, Mr. Clean, and Top Job, or a mild dishwashing detergent such as Ivory® Liquid. Follow
the manufacturers’ directions and precausions. Rinse well and dry with a clean cloth.
•
Do not use products such as acetone (nail polish remover), dry cleaning solution, lacquer thinners, gasoline, pine oil,
wintergreen, etc.
•
Use Isopropyl rubbing alcohol to clean grease oil, paint or ink. Dry with a clean soft cloth.
•
Avoid using razor blades, putty knives, or other metal instruments that might scratch the surface. Small scratches can
be removed by applying a thin coat of automotive paste wax and buffing lightly with a clean cloth. For deeper scratches
sand the surface lightly with 600 grit “wet or dry” sand paper, rub out with fine buffing compound, and apply a coat of wa
WARNING: Flush the whirlpool system periodically (at least every 90 days) as follows: Fill the bathtub with water, add
1/2 cup of household bleach, run the whirlpool system for 10 minutes, drain completely. Rinse the bathtub and refill with
water, run the whirlpool system for 5 minutes, drain completely. Wipe dry with a soft cloth.
DESIGNER COLLECTION 99/9 LIMITED WARRANTY
To prove our commitment and ensure your continued satisfaction with your bathtub, we back our product with the
best warranty in the business - our 99/9 warranty. Hydro Systems, Inc. warrants to the original purchaser of the
Combination, Whirlpool or Thermal Air, that the shell will maintain its structural integrity and configuration and will be
free of water loss due to a defect in the tub shell for a period of 99 years from the purchase date. The warranty
covers the tub shell against defects in materials and workmanship. The warranty does not apply to any other
component or plumbing component, as they are covered under separate warranties.
Hydro Systems, Inc. warrants to the original purchaser of the Thermal Air or LED Lighting Tub that all support
equipment, controls and plumbing components (excluding plumbing fittings and piping) for a period of 9 years from
the purchase date. Limited labor is covered for the first 3 years of ownership, starting from the date of purchase and
not the date of installation.