Installation Sheet
– 6 –
Figure 3
Whirlpool Jets
Safety Suction Cover
Air Switch ON/OFF
OPERATING INSTRUCTIONS
WARNING: To reduce the risk of injury, do not permit children to use this unit unless they are closely
supervised at all times.
•
Use this bathtub only for its intended use as described in this manual. Do not use attachments not recommended
by Hydro Systems.
•
Never insert or drop any object into any opening.
•
Do not operate this unit without the cover over the suction tting.
•
Hydro Systems tubs are designed for “ll-and-drain” use. Fill the tub to use it and drain it when you are nished.
Note: The pump motor is equipped with a thermal overload protector which senses current and temperature. The
motor will shut down automatically in the event of an unsafe condition. If this happens, turn the whirlpool system off.
When the unsafe condition has been corrected the motor is automatically ready to restart.
TO OPERATE:
Fill the tub with water at the desired temperature and push in air switch. When you’re sitting in the tub the
water level should be at least 1" above all jets but lower than the overow. Each Hydro Systems Studio series whirl-
pool bathtub is equipped with these standard features (Figure 3).