Owner's manual

- 7 -
PRODUCT WATER FAUCET INSTALLATION - POLYMER FAUCET
Install on flat surface at least 2 7/16" in diameter. Unused 1 1/4"- 1 7/16" opening is ideal.
New Faucet Installation
Refer to Faucet Site Preparation, Page 4.
Replacement Faucet Installation
Verify size of existing hole. If hole measures 1 7/16",
Faucet may be installed without changes. If hole measures
1 1/4", remove two locator tabs (Figure 8) prior to
installation by breaking them off at faucet base.
FAUCET BODY
TAB
Figure 8 Faucet Locator Tabs and Air Gap.
1. Remove mounting nut and "U" bracket from faucet.
2. Install 3/8" blue tube into blue collet in faucet base.
3. CAUTION: Do not pinch, kink, pull, or otherwise
deform monitor cord.
Hydrotap

Logo (without Light Bar): Insert blue
tube into mounting hole and place faucet over hole.
Align faucet body with narrow face forward.
Smartap

Logo (with Light Bar): Insert blue tube
and monitor cord into mounting hole and place faucet
over hole. Align faucet body with light bar forward.
4. Install "U" bracket and mounting nut below sink.
Tighten mounting nut by hand
so that faucet does not
move. Do not over tighten.
NOTE: Faucet is packaged for right-hand operation. For
left-hand operation, realign handle by completing Step 5.
NOTE: Item callouts in Step 5 refer to Page 8,
Figure 9.
5. Align faucet knob for left-hand operation.
a. Rotate knob to rear of faucet (closed position).
b. Remove knob cover (Item 1) using a thin, flat tool
to pry cover from knob.
c. Remove knob attachment screw (Item 2) using a
Phillips-head screwdriver.
d. Remove knob (Item 3) by pulling it (by hand)
straight up. Rotate handle counterclockwise 90º,
and re-install knob.
e. Install knob attachment screw. Tighten screw
until free movement (i.e., rocking) is eliminated.
f. Snap knob cover into place.
6. Install spout into faucet body. Lubricate “O” ring with
FDA approved Silicone Lubricant. Align spout with
faucet outlet, gently push spout to bottom of outlet.
7. Light Bar: Connect monitor cord to module. Insert
cord into a telephone-style connector located on
module cover (See Page 5, Figure 6).
8. CAUTION: Blue 3/8" tube connecting module to the
product water faucet must run with no sharp bends or
loops (See Page II, Figure 1).
Connect 3/8" blue tube to swivel elbow located on
rear of module.
9. The basic installation is complete and system is ready
for activation (see Page 10).
CLEAN FAUCET SURFACE USING DISHWASHING DETERGENT ONLY. DO NOT USE ABRASIVES OR SOLVENTS.