Owner's manual

- 10 -
ACTIVATING THE SYSTEM
CAUTION: Make sure all water supply lines, drain lines, and fittings are secure and free from leakage.
1. Open saddle-tapping valve. Check for leakage.
2. Open product water faucet and let water flow to drain
for at least 10 minutes. This will expel the air from the
system.
3. Close product water faucet. In 5 minutes, check the
connections for leaks and correct if necessary
Icemaker/Extra point of use
: Check connections on
these supply lines for leaks.
NOTE: Item Callouts refer to Page 9, Figure 10 unless
noted otherwise.
Systems with Smartap Water Flow Monitor complete
Steps 4 through 7.
4. CAUTION: Wiring within module cover connects
monitor components. If wires, circuit board, or
connections are damaged and/or wetted, monitor will
not function.
Loosen mounting bracket screws (Item 3). Gently pull
module cover (Item 1) up and away from the manifold
body.
5. CAUTION: Verify battery connector alignment before
making connection (Figure 11).
Connect battery (Item 24) by pressing clip onto battery
terminals.
6. Replace module cover and tighten screws.
7. Test battery connection by activating monitor. Open
product water faucet or press push button, whichever
is applicable. If an indicator light illuminates,
connection is good.
NOTE: Close faucet immediately after light
illuminates. Test is to confirm battery connection, not
water quality.
Icemaker
: Let tray/bin fill with ice cubes. Discard all
ice cubes. This flushes sanitizing solution from lines
to icemaker.
8. System is ready to use. Should there be any
aftertaste or odor to water or ice cubes, repeat
Steps 6 and 7.
MAINTENANCE - WARRANTY INFORMATION
Recommended Service Intervals Warranty
Replace filters as required based on Smartap
®
Water Flow Monitor indications
or every 6 to 12 months depending on feed water quality.
System: 2 years limited
Smartap
®
: 5 years
CRITICAL COMPONENTS
Non-Air Gap Metal Faucet Part Number Non-Air Gap Polymer Faucet
Black/Chrome
Part Number Carbon Cartridges Part Number
Chrome Plated Brass*
Chrome Plated Brass**
Stainless Steel
Stainless Steel with Light Bar
40301102
40301002
40301003
11702002
Polymer, Hydrotap

Logo
Polymer, Smartap
®
Logo
(with Light Bar)
11411100
11402320
Lead Reduction (Black Cap)
VOC Reduction (White Cap)
41400010
41400011
* Faucet not available in California
**EPA and California Proposition 65 Compliant
PARTS AND SERVICE ARE AVAILABLE THROUGH YOUR LOCAL WATER TREATMENT DEALER.