Instructions / Assembly

4
DRAIN OUTLET ASSEMBLY INSTALLATION
NOTE: State, provincial and local plumbing codes may prohibit use of saddle-tapping drain connections and may
require use of an air gap.
NOTE: Location and orientation of drain outlet assembly is vital to system performance.
Horizontal Drain Line
:
Locate drain hole as close as possible to top of pipe
(between 45º and top) and as far as practical from
garbage disposal.
Vertical Drain Line
:
Locate drain hole on a straight length of drainpipe next to
"P"/"S" trap between trap and sink.
Figure 4: Drain Hole Location and Installation, Air Gap Faucet
NOTE: See Page III, Figure 1.A. for connection to drain for Non-Air Gap Faucet.
1. Select a location for drain hole based on type of sink
and orientation of drain line (Figure 4).
NOTE: Item callouts refer to Figure 5 unless noted
otherwise.
2. Position drain outlet saddle (Item 1) on drainpipe.
Allow adequate space for drilling operation.
3. Tighten saddle bolts evenly on both sides. Avoid over-
tightening.
4. Using opening in drain saddle outlet as a guide, drill a
3/8" to 7/16" diameter hole in drainpipe. Clean any
debris out of drain saddle connection.
Item Description Part No.
1
1A
Drain Saddle, Air Gap, 3/8” Connection
Drain Saddle, Non-Air Gap, 1/4” Connection
92160
92159
Figure 5: Drain Outlet Assembly