Phau Ntawv Qhia

WSV6 VERTICAL SERIES - IOM
16 WSV6 Vertical Series – IOM
INSTALLATION
REQUIREMENTS
Follow manufacturer’s installation instructions, as well as
local and municipal building codes.
INSTALLATION PRECAUTIONS

Always wear all appropriate personal protection
Equipment when installing and servicing these units.

Use multiple people when moving and installing these
units. Failure to do so could result in injury or death.

Contact with metal edges and corners can result injury.
Protective gloves should be worn when handling.
Exercise caution when installing and servicing unit.
Observe the following precautions for typical installation:
 Always use proper tools and equipment.
 No wiring or any work should be attempted without
first ensuring the unit is completely disconnected from
the power source and locked out. Also, verify that a
proper permanent and uninterrupted, ground
connection exists prior to energizing power to the
unit.
 Review unit nameplate and wiring diagram for proper
voltage and control configurations. This information
may vary from unit to unit.

When the unit is in operation components are rotating at
high speeds and caution should be taken.


When soldering and brazing, it is recommended to have a
fire extinguisher readily available. When soldering and
brazing close to valves or sensitive components, heat
shields or wet rags are required to prevent damage to the
valves or components.

Insulation is installed in the unit to provide a barrier
between varying atmospheres outside and within the unit.
If insulation is damaged condensation can occur and can
lead to corrosion, component failure, and possible
property damage. Damaged insulation must be repaired
prior to the operation of the unit. Insulation will lose its
effectiveness and value when wet, torn, separated, and/or
damaged.

When servicing this equipment, because of high pressures,
make sure the reversing valve, expansion device, filter
drier and other components are specifically designed for
R-410A refrigerant.
ONLY USE service equipment specifically designated for
use with R-410A.

R-410A can become combustible if mixed with air at
elevated temperature and/or pressure. Failure to follow
this warning could result in property damage and personal
injury or death.

Do not operate this equipment without an air filter.