NOTES DISHWASHER INSTALLATION AND USE AHY8122 0120501055
Safety Is a Good Habit to Get Into NOTICE Carefully read the instructions contained in this manual, as they provide importion which is essential to safe and proper installation, use and maintenance of the appliance.
Salt Close-up View (Interior) Salt The hardness of the water varies from place to place. If hard Adjusting Salt Consumption water is used in the dishwasher, deposits will form on the dishes utensils.
Loading the Dishwasher Detergent and Rinse Aid Detergent Rinse Aid Detergent specifically intended for use with dishwashers must This product makes dishes sparkle and helps them to dry with- Before placing the dishes in the dishwasher, remove the large food particles to prevent the filter from becoming clogged, which re- be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle out spotting.
Turning on the Appliance Wash Cycle Table Starting a wash cycle - Make sure that the plug for the appliance is inserted into the wall socket. Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more - Make sure that the water supply is turned on to full pressure. - Load the dishwasher (see the section entitled, "Loading the susceptible to breakage. They will also dry better.
Energy Saving Tips Cleaning and Special Maintenance Filter Assembly For best performance and results, the filter assembly must be cleaned. loaded to save on energy. In order to prevent odors from form- - Use the right amount of detergent: if you use too much detergent, the result will not be cleaner dishes, but, rather, a greater nega The filter efficiently removes food particles from the wash water, allowing it to be recirculated during the cycle.
Installation Installation Important: Any electrical or plumbing work required to install this appliance, should be carried out by a qualified Hot Water Connection electrician or qualified plumber. house's hot water line (centralized system, heating system), as long as it does not exceed a temperature of 60 . Positioning the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent cabinets or wall.
Electrical Safety Instruction WARNING! THIS APPLIANCE MUST BE EARTHED CONNECTION TO A REWIREALE PLUG If the fitted plug is not suitable for your socket outlet, then it should IF THE MAINS LEAD OF THE APPLIANCE IS FITTED be cut off and disposed of order to avoid a possible shock hazard should it be inserted into a 18A socket elsewhere. A suitable alterWITH A PLUG: native plug should then be fitted to the cable.