Owner manual

Optional Winch Installation

C:\Users\RHerd\AppData\Local\Temp\JK-10SAD InstallationInstructions.doc Page 1 of 2

REV 0 9/4/2009

Proudly Made In USA

Installation Instructions:

JK Standard Air Dam

Part Number: JK-10SAD

Vehicle Fitment:

Fits Hyline Offroad Standard

Front Bumper (P/n JK-10SFB)

Parts List

Qty:

1 Standard Air Dam

4 3/8-16 x 1” Gr. 5 Bolts

4 Lock Washers

4 Flat Washers

2 3/8” Nuts

Tools Needed

Ratchet

9/16” Socket

6” Extention

9/16” Wrench

Congratulations on your purchase of the Hyline Offroad Standard Air Dam. Our products are completely

manufactured in our facility located in Perkasie, PA. They are designed and engineered by Offroad enthusiasts just

like you to be rock solid at an affordable price. Hyline Offroad would like to thank you for your recent purchase

and look forward to serving you in the future.

Hyline Offroad Staff

PAGE 1
Proudly Made In USA Installation Instructions: JK Standard Air Dam Part Number: JK-10SAD Parts List Qty: 1 4 4 4 2 Standard Air Dam 3/8-16 x 1” Gr. 5 Bolts Lock Washers Flat Washers 3/8” Nuts Vehicle Fitment: Fits Hyline Offroad Standard Front Bumper (P/n JK-10SFB) Tools Needed Ratchet 9/16” Socket 6” Extention 9/16” Wrench Congratulations on your purchase of the Hyline Offroad Standard Air Dam. Our products are completely manufactured in our facility located in Perkasie, PA.
PAGE 2
PLEASE READ INSTRUCTIONS BEFORE BEGINNING INSTALLATION Air Dam Installation Step 1 – Before installing your Air Dam make sure there are no wires in your way. Step 2 – After installing your Hyline Standard Front Bumper you can install your Air Dam Skid Plate. Using the 9/16” socket with 6” extension, place the 3/8-16 bolt with lock washer and flat washer into the socket. While holding the Air Dam in place, thread the 3/8 bolt through the slots and into the weldnut in the bumper.