Owner's manual

Q:\Hyline Offroad, LLC\Installation Instructions\400.300.110-JK ROCK SLIDER (2 DOOR)\400.300.110 Installation Instructions.doc Page 1 of 4

REV 1 1/21/14

Proudly Made In USA

Installation Instructions:

JK Tube Step Rocker Panel

Part Number: 400.300.110

Vehicle Fitment:

2007-Present Jeep Wrangler

2-Door Only

Parts List

Qty:

1 Driver Rock Slider – RED Dot

1 Passenger Rock Slider – GREEN Dot

1 Driver Drill Template – RED Dot

1 Passenger Drill Template – GREEN Dot

8 3/8-16 Gr 5 Hex Nuts

8 3/8” USS Flat Washers Gr 5

8 3/8” Split Lock Washers Gr 5

4 3/8-16 Threaded U-Bolts

4 Square Plastic End Caps

8 3/8” Retaining Rings

Tools Needed

Ratchet & Sockets

5/8”, 9/16” 18mm &

19mm

Drill

3/16” & 1/2”

Multi-Depth or Step

Drill Bit Recommended

Congratulations on your purchase of the Hyline Offroad Rock Sliders. All of our products are

completely manufactured in our facility located in Perkasie, PA. They are designed and engineered by

Offroad enthusiasts just like you to be rock solid. Hyline Offroad would like to thank you for your

recent purchase and look forward to serving you in the future.

Hyline Offroad Staff

Safety Glasses

PAGE 1
Proudly Made In USA Installation Instructions: JK Tube Step Rocker Panel Part Number: 400.300.
PAGE 2
1. Remove any stock rock rails or factory tube steps from vehicle if equipped. Passenger Side Installation: Note: You will also need to remove the factory Rubicon Rails if vehicle is equipped with them. 2. Remove the two existing bolts from underside of frame rail. This should drop the skid plate crossmembers just enough to slide the Passenger Side steel drill template in place. The Passenger Side Template will have a GREEN Dot located on it. 3.
PAGE 3
7. Now install the supplied 3/8-16 Threaded U-Bolts by inserting one end first, then feeding and turning the U-Bolt until you fish it out the other hole. Do this before installing the Rock Sliders. Press on the provided Retaining Rings immediately after the U-Bolt is installed to prevent from slipping into frame. (Figure 2) Helpful Tip When Installing the Retaining Rings: Once you have the U-Bolt in the frame, install a washer and nut on one side of the U-Bolt.
PAGE 4
14. Repeat and follow steps 4-10 for installation on the Driver Side. 15. Install Black Plastic Tube Caps in each end of Rock Slider tube. 16. You’re installation is now complete. Send your Photos to pics@HylineOffroad.com . If we choose any one of your pictures to be used on our website, We’ll send you a FREE Hyline Offroad T-Shirt Q:\Hyline Offroad, LLC\Installation Instructions\400.300.110-JK ROCK SLIDER (2 DOOR)\400.300.110 Installation Instructions.