Instructions / Assembly

ManualsBrandsHyLoft ManualsStorage & Organization96 in. x 48 in. Ceiling Mounted Storage Unit

Safety:

Read and understand the warning on your stepladder and make sure the ladder is in good working

order.

Examine all tools needed to insure they are in proper working order before starting.

Power tools that are not internally grounded require power cords and extension cords with a ground

prong.

Always wear eye protection when drilling or installing parts.

components are made of metal so beware of any sharp edges and do not let any components

make contact with electrical current during installation.

DO NOT install more than one unit on any two framing members.

Preparation:

The unit can be installed in any area of garage, provided there is adequate space. When

possible install so that all four sides are accessible for convenient loading.

Take care not to block attic or crawl space access, or lights.

If ceiling height allows for it, the unit may also be installed above the open garage door . If installing

above an open door, measure between the highest point of the opening garage door and the ceiling to

determine if there is adequate room for the unit. You will need at least 25 inches of open space

between the ceiling and the highest point of the door during operation.

Clear the area where the unit is to be installed, and don’t leave autos parked under the unit

during installation.

Locate any gas, electrical, and plumbing lines in the garage before drilling holes in the drywall.

NOTE: We refer to Joists throughout the instructions. Joists are also called Ceiling Studs or Framing

Members.

HyLoft

1-800-253-1561

, accessories

Knape & Vogt®

Grand Rapids, MI 49505 USA

For more information and frequently asked questions, visit our web site:

www.Hyloft.com

Preparation and Safety Information

IMPORTANT-READ THROUGH ENTIRE INSTRUCTIONS BEFORE BEGINNING INSTALLATION

Summary of content (5 pages)

PAGE 1
Preparation and Safety Information IMPORTANT-READ THROUGH ENTIRE INSTRUCTIONS BEFORE BEGINNING INSTALLATION Safety: Read and understand the warning on your stepladder and make sure the ladder is in good working order. Examine all tools needed to insure they are in proper working order before starting. Power tools that are not internally grounded require power cords and extension cords with a ground prong. Always wear eye protection when drilling or installing parts.
PAGE 2
ASSEMBLY INSTRUCTIONS SuperPro 48" X 96" Ceiling Mounted Shelf Item # 00164 Joists 24" to 42" apart O M Parts Included: IMPORTANT-Read through entire instructions before beginning any installation.
PAGE 3
IMPORTANT-READ THROUGH ENTIRE INSTRUCTIONS BEFORE BEGINNING INSTALLATION Locate the ceiling joists in the area of desired installation and determine the direction in which they are running. The ceiling Angle Brackets(B) are installed parallel to the ceiling joists. Refer to the diagram below for additional installation clarification.
PAGE 4
ATTACH SUPPORT FRAMES M M Place two 48" Support Frames(F) on top of feet and using Clamps(K) with thick part up, fasten to downrod using Hex Bolts(L) and Nuts(J). Make sure ends of Support Frames(F) are even and square. Place 96" Support Frames(G) on top of 48" Support Frames (F) and loosely bolt together in each corner using ¼" Hex Bolts(M) and Nuts(N) using a 7/16" wrench or nut driver. Do not tighten until after placing grids.
PAGE 5
SuperPro 48" X 96" Ceiling Mounted Shelf Item # 00164 ALTERNATE INSTALLATIONS Multi-Directional Joists: If joists change direction, 2 or all 4 Downrods (C&E) can be installed on the 96" side. Rotate direction of Angle Brackets (B) and Downrods (C&E) & install as shown in steps 1-3 of original instructions.