Instructions / Assembly

ManualsBrandsHyLoft ManualsStorage & Organization36 in. x 36 in. Adjustable Height Ceiling Storage Unit

Parts Included:

2 Carriage Bolts

#8-32 X 3/4”(3 mm x 19 mm)

8 Lag Screws

;ò

4 Carriage Bolts ” x 1

(6 mm x 32 mm)

¼”

2 wire grids

18”wide (46 cm)

8 Downrods Bent

2 Crossbars

12 Hex Bolts

” X ½”(6 mm x 13 mm)¼

HyLoft Sticker

These Instructions

and

Limited Warranty

2 Plastic Tie Straps

16 Hex Nuts

Serrated ”(6 mm) ¼

4 Sinker Nails

Joists

24" to 32"

apart

Sinker Nail

Hammer Framing

Square

(optional)

PencilDrill Bit Hand or

Power Drill

Ladder or

Step Stool

Tape Measure

Eye Protection

7/16" Wrench

(11 mm)

Stud/Joist

Finder

(optional)

7/16"(11 mm)

Socket Wrench

or Nut Driver

ASSEMBLY INSTRUCTIONS

3 ft. x 3 ft. Ceiling Mounted Shelf

Item # 00720

Tools Required:

IMPORTANT-Read through entire instructions before beginning any installation.

MISSING A PART?

There is no need to

return this item to the

store. Instead call our

TOLL FREE HOTLINE.

1-800-990-6003

Purchaser assumes all liability

if load exceeds 150 lbs. or if

improperly installed.

www.hyloft.com

(8mm x 63mm)

Summary of content (3 pages)

PAGE 1
ASSEMBLY INSTRUCTIONS Item # 00720 3 ft. x 3 ft. Ceiling Mounted Shelf MISSING A PART? There is no need to return this item to the store. Instead call our TOLL FREE HOTLINE. Joists 24" to 32" apart 1-800-990-6003 Sinker Nail Parts Included: J IMPORTANT-Read through entire instructions before beginning any installation.
PAGE 2
IMPORTANT-Read through entire instructions before beginning any installation. Determine where the Hyloft 3 x 3 unit will be installed, such as in a pantry, bedroom, laundry room, closet or garage. (If installing above the open garage door you will need at least 17" of open space between the highest point of door and the ceiling as measured during its upward travel.) Map out the ceiling area of the room where you are installing your unit.
PAGE 3
ATTACH CROSSBARS AND ADJUST HEIGHT Adjust Downrods to Desired Length 2A Connect each Crossbar(B) to 2 Downrods(C) using 2nd holes from ends 2B Connect Crossbar and Lower Downrods to Ceiling Downrods PLACE AND ATTACH GRIDS 3A Lay Wire Grids(A) evenly on Support Bars and attach as shown. Note: Long grid wires are on the bottom and extend past support bars equally on both sides. Sticker four-wire clusters nearest downrods 3B Fasten together Grids (A) using 2 Plastic Tie Straps (I).