Installation Guide

ManualsBrandsHyLoft ManualsStorage & Organization60 in. x 45 in. Adjustable Height Pro Ceiling Storage Unit

Parts Included:

15" x 45"

4-Wire Grids 4-Corner rods

4-Downrods

4-Hex Nuts

6-32

4-Washers

6-32

Framing

Square

(optional)

Pencil

3/16"

Drill Bit

(4.8mm)

Power

Drill

Ladder or

Step Stool

Tape Measure

Eye Protection

7/16" Wrench

(11 mm)

Stud/Joist

Finder

(optional)

7/16"(11 mm)

Socket Wrench

or Nut Driver

Tools Required:

IMPORTANT-Read through entire instructions before beginning any installation.

2-Support Bars

8-Lag Screws 5/16" X 2 ½"

16-Hex Bolts ¼" x 1½"

24-Hex Nuts Serrated ¼"

Joists

24" to 32"

apart

ASSEMBLY INSTRUCTIONS

60" x 45" Ceiling Mounted Shelf

Item # 00175 or

#50175-10

MISSING A PART?

There is no need to

return this item to the

store. Instead call our

TOLL FREE HOTLINE.



4-Carriage Bolts 6-32 x 2"

8-Carriage Bolts ¼" x 2"

Summary of content (3 pages)

PAGE 1
ASSEMBLY INSTRUCTIONS Item # 00175 or #50175-10 60" x 45" Ceiling Mounted Shelf MISSING A PART? There is no need to return this item to the store. Instead call our TOLL FREE HOTLINE. Joists 24" to 32" apart I Parts Included: IMPORTANT-Read through entire instructions before beginning any installation.
PAGE 2
IMPORTANT-READ THROUGH ENTIRE INSTRUCTIONS BEFORE BEGINNING INSTALLATION Locate the ceiling joists in the area of desired installation and determine the direction in which they are running. The ceiling mounting plates on Downrods(B) are installed parallel to the ceiling joists. Refer to the diagram below for additional installation clarification.
PAGE 3
INSTALL GRIDS J Quad wires Quad wires Quad wires J Place Grids(A) across the two hanging Support Arm (D) assemblies making sure the long wires of the Grids (A) are facing down and overhang is even on both sides. Quad wires go to the inside on the center Grids(A) and to the outside on the outer Grids(A). Fasten 2 center Grids(A) to Support Bars (D) through the quad wire section of the Grids (A) using (4) ¼ x 2" Carriage Bolts (J) and ¼" serrated nuts (K) as shown. DO NOT TIGHTEN AT THIS TIME.