Installation Guide

Page 4
Place the HyLoft Sticker (I) provided on the Corner Rod (A) for easy access to contact information.
Make sure that all nuts, bolts and screws are tight. Maximum 200 lbs. combined load per unit,
evenly distributed.
Determine location needed for storage and insert Downrods (A) through grid of existing HyLoft Rack
at an angle. Straighten and pull down Downrods (A) until the top of the Downrod hooks over the grid
wires as shown. Continue with step 2 on previous page to install Corner Rods (B & C) and Support
Bars (D & E), adjusting height and width as needed.
3. Tighten All Hardware
Alternate Installation on to Existing HyLoft Unit
Combined storage weight of both racks must not exceed 200 lbs., evenly distributed.
Periodically (at least annually) check all connections to ensure that they remain tightly fastened.
310484/0915