Hyperice X Operating Instructions
EN IMPORTANT SAFETY INSTRUCTIONS Read the entire instruction manual before using the Hyperice X. ⚠WARNING! No modification of this equipment is allowed. ⚠WARNING! If you experience severe pain, any unusual symptoms, or want to remove the device in an emergency during use: • Stop the temperature control by pressing the power button. • Remove the device from your body. • Promptly consult your licensed healthcare practitioner, as required. ⚠CAUTION! • Do not attempt to take apart the device.
Symbol IP22 93%RH 10%RH 1060hPa 700hPa -20ºC -4ºF 70ºC 158ºF Description Location Degree of protection against ingress of water On product Level of protection type BF equipment On product Double insulation On charger Direct current On product Alternating current In manual Manufacturer’s name and address On product Date of manufacture On product Separate collection for waste electrical and electronic equipment On product Serial number of the console On product Fragile, handle with
the temperature of the treatment area feels uncomfortable, you can reduce the intensity or stop the session. Like using an ice or heat compress, the benefits include temporary pain and inflammation relief, as well as soothing joints and relaxing muscles in the treatment area.
With minimizers in place: Using the Extenders If the device straps are too short use the extenders to get a custom fit. Attach the extenders: With extenders in place: Caring for the Device Cleaning the Device • Wipe down the treatment pad with a damp, clean cloth. • Dry thoroughly with a clean cloth. • Do not machine wash or dry. • Do not dry clean. Maintaining the Device The device and power supply require no routine maintenance or service except for the care in this section.
The Hyperice X device uses Bluetooth 5.0 wireless technology with the following radio specifications: Frequency 2.4GHz ISM ( 2.36000 – 2.4835GHz) Modulations GFSK at 1 Mbps, 2 Mbps data rates Transmit Power 0 dBm Sensitivity -96dBm Bluetooth, -89dBm at 2Mbs Security 128-bit AES ECB/CCM/AAR co-processor FCC ID: 2AWOM-1040001 This device complies with part 15 of the FCC Rules.
General Notes Medical electrical equipment requires special precautions regarding electromagnetic compatibility (EMC) and needs to be installed and put into service according to the EMC information provided in this document and the remainder of the instructions for use of this electronics box. Portable and mobile RF communications equipment can affect medical electrical equipment. Cables and accessories not specified within the instructions for use are not authorized.
Power frequency magnetic field 50/60 Hz (IEC 61000-4-8) 30 A/m 30 A/m Equipment that emits high levels of power line magnetic fields (in excess of 3A/m) should be kept at a distance to reduce the likelihood of interference. Voltage dips and short interruptions on AC mains input lines (IEC 61000-4-11) Dip > 95%, 0.5 cycles Dip > 95%, 1 cycle Dip 30%, 25 cycles (50 Hz) 0.
Recommended Separation Distances Recommended separation distances between portable and mobile RF communications equipment and the Hyperice X electronics box. Rated maximum output power of transmitter W Separation distance according to frequency of transmitters in meters 150 kHz – 80 MHz d=1.2/V1]√P 80 MHz to 800MHz d=1.2/V1]√P 800 MHz to 2.5 GHz d=2.3√P 0.01 0.12 0.12 0.23 0.1 0.38 0.38 0.73 1 1.2 1.2 2.3 10 3.8 3.8 7.
Device is not responding. Firmware may have crashed. Reset the device by plugging in the wall charger and holding the power button down for 10 seconds. Low Battery Battery needs to be charged. Plug in the electronics box to charge the battery. Cannot establish or maintain a Bluetooth connection Bluetooth is turned off. Turn on Bluetooth on the phone attempting to pair with the Hyperice X unit. Call Hyperice customer service at +1.949.565.4994 if further assistance is needed.
• Returns must be shipped within 30 days of the purchase date; exchanges must be shipped within 14 days of the purchase date. • Products and packaging must be returned in new and undamaged condition. Any products showing signs of wear or being soiled in any way will be deemed “unacceptable,” and you will be so notified. Unacceptable returns and/or exchanges may be reshipped to you following payment of an inspection/shipping fee. • Returned items will be subject to a 7.5% restocking fee.
hyperice.com This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Hyperice, Inc., 525 Technology Drive, Suite 100, Irvine, California 92618 USA Copyright 2021 © Hyperice, Inc. All rights reserved.
