- HyperNet PCMCIA 10/100 TX, HYNEP61001 PC Card USER GUIDE

Hardware Installation
The HyperNet PCMCIA 10/100 TX hardware installation is a three step process:
1. Insert the HyperNet adapter into the computers PCMCIA slot
2. Connect the media coupler to the HyperNet adapter
3. Attach the network cable
The HyperNet PCMCIA 10/100 TX adapter is a Type 11 PC Card which is compatible with any Type 11 PCMCIA slot. If your computer has
more than one slot, you may insert the adapter in any of them. The software will automatically determine into which slot the adapter is inserted.
Gently insert the card into the PCMCIA slot, pushing until it sits firmly in place, care must be taken not to force it as the adapter is 'keyed' to fit
only one way. If it does not register smoothly, withdraw it and check that the keyed plug on the adapter is correctly aligned with the keyed socket
in the host PC.
Now attach the media coupler to the 15-pin keyed socket on the exposed end of the adapter. This media coupler will have an RJ45 female
connector that supports both 10Mbps and 100Mbps networks, insert your RJ45 cable into this connector on the coupler, and insert the other end
to the wall socket or Ethernet hub.
Windows Installation for Set-Up Guide
To install the HyperNet PCMCIA 10/100 TX using Windows, follow the instructions on the Online User Guide once installed as below:
1 Start Windows.
2 Insert the HyperNet software disk into the PC disk drive.
3 From the Program Manager, select File Menu.
(For Windows 95, select the start menu)
4 Select Run…
5 Type A:\SETUP and select OK.
6 Follow the Help utility's on-screen instructions for the setup process.
DOS Installation
Look at the README file.
Software Included
 ODI workstation drivers for Novell NetWare, NetWare Lite, and Novell DOS 7
 NDIS 2.0.1 driver for Microsoft LAN Manager, Windows for Workgroups, Artisoft LANtastic
 NDIS 3 for Windows 98, Windows 95 and Windows NT
 Wizard utility for installation, self-test and diagnostics
Disconnecting the HyperNet PCMCIA 10/100 TX
Please ensure that the operating system allows you to remove the card while the system is running before trying to do so, if in doubt then shut
down you computer before removing the adapter.
To remove the card from the computer PCMCIA slot, activate the release switch located on your computer. Alternatively, you may simply
disconnect the media coupler, and leave the HyperNet Card in place in the slot ready for you to use it next time you need it.
To remove the media coupler from the card, gently squeeze the plastic clip depressors located on the coupler and separate it from the card.
Never disconnect the HyperNet Card by pulling on the cable.
If at any time during installation you experience difficulties, please contact Hypertec Technical Support on [phone] (01488 686844 in
the UK).