User Guide

Overview
HyperX Cloud Buds TWS
Quick Start Guide
4402224
A
E
G
C
B
D
F
Touch sensor
A
Charging pinsD
Ear tips
G
Microphone
B
Charging contacts
C
Charging case status LED
E
USB-C charging port
F
Powering on and off the Earbuds
To power on the earbuds, open the charging case.
The earbuds will play a rising tone and automatically reconnect to the last paired device.
To power off the earbuds, return them to the charging case and close the lid.
The earbuds will play a falling tone and automatically begin charging.
Wearing the Earbuds
Controls
Status LED
Charging
1. Gently insert the earbuds into the ear canals.
2. Slightly rotate the earbuds until the earbuds fit comfortably in the ear and are stable.
To check the charging case battery level, open the lid with the earbuds inside.
Questions or Setup Issues?
Contact the HyperX support team or see the user manual at:
hyperxgaming.com/support/headsets
WARNING: Permanent hearing damage can occur if a headset is used at
high volumes for extended periods of time.
Pairing the Earbuds
1. With the earbuds inserted, open the lid of the charging case.
2. If there are no previous connections, the earbuds will automatically enter pairing mode.
Otherwise, press and hold the pairing button on the charging case for 3 seconds.
3. On your device, search for nearby Bluetooth devices and select HyperX Cloud Buds TWS.
The earbuds will play a quick double beep once the connection is successful.
Pair new device
Available devices
HyperX Cloud Buds TWS
Tap to play/pause music, answer/end calls
Double tap to skip to next song
Triple tap to go to previous song
Hold for 2 seconds to reject call
LEDCHARGING CASE BATTERY LEVEL
Solid green for 5 seconds50% - 100%
Blinking green for 5 seconds25% - 50%
Breathing red for 5 seconds< 25%
LEDSTATUS
Breathing redCase and earbuds charging
Solid green for 5 minutesCase fully charged
Breathing greenEarbuds charging
OFFEarbuds fully charged
简体中文
概述
A - 触控板
B - 麦克风
C - 充电触点
D - 充电针
E - 充电盒指示灯
F - Type-C 充电端口
G - 耳套
操作方式
打开充电盒盖子耳机即自动开机，开机后自动回连上一次配对的设备。
将耳机放回充电盒关闭充电盒盖，耳机自动关机并充电
双耳配对
1. 将耳机放入充电盒内，打开充电盒盖
2. 如果之前无任何配对使用操作，耳机将自动进入配对模式。否则，需按住充电盒上的配对按钮
3 秒钟进
入重新配对模式
3. 打开设备蓝牙列表搜索“HyperX Cloud Buds TWS”点击完成连接，快节奏提示音“di du”。
佩戴方式
1. 将耳机斜向下轻轻塞入耳道。
2. 轻摆头部耳机不晃动为宜。
单/双耳触控模式
LED 状态
耳机装入充电盒并打开充电盒盖，确认充电状态
触摸耳机播放/暂停 音乐, 接听/挂断电话
触摸
2 次耳机播放下一曲
触摸
3 次耳机播放上一曲
耳机触摸保持
2 秒拒接电话