User's Manual

DS-6210 Base Station Owner's Manual Installation
27
3.4 Unpacking Inspection
3.4.1 Check before Unpacking
After the equipment arrives at the installation site, you should:
z Check against the packing list, including total amount, customer address, and etc.
z Contact us in case of any mistake.
z Check the packaging case is in good condition and not placed upside down.
If the outer package is damaged seriously or soaked, please contact us immediately.
Note:
To protect the equipment and investigate the cause, please properly keep the package box, equipment and
packing materials, and take photo.
If the above check results are good, unpack and check the equipment.
3.4.2 Unpacking Wooden Case
Caution:
z Keep the wooden case far away from intense shock during transportation.
z Never touch the parts with dirty glove during transportation.
If space permitting, carry the wooden case into or near the computer room before unpacking. This can
prevent the chassis from being damaged.
To unpack the wooden case, do as follows:
Step 1 Wear the ESD-preventive glove.
Step 2 Lay the wooden case horizontally on the ground. Do keep the side with frame down.
Insert one end of the slot type screwdriver into the seam between the cover and the case body by the
claw hammer; then remove all nails, as shown in
Figure 3-2.
Tools
Claw hammer and slot type screwdriver