Users Manual

The radio must work with a 13.6V negative ground electrical system only. Ensure to check the ground
4
2. Installation
2.1 Instructions
Before installing the radio in a vehicle, read the following instructions carefully:

polarity and voltage of the vehicle power supply prior to installation.

Check how long the screws will extend from the bottom surface of the radio. Drill the mounting hole cautiously to
avoid damage to the vehicle wiring and other parts.

Connect the antenna and power cord to the radio before you install the radio in the bracket. Make sure the antenna
and power cord are dedicated for digital radios of the Company.

Install the radio with mounting bracket supplied by the Company, to avoid radio looseness in case of accidents.
The loose radio may cause bodily injury.

Install the radio in a location where you can reach the front panel conveniently.

Keep sufficient clearance at the back of the radio for wiring.

Be sure to use the fuse with the same specification for DC power cord upon replacement.

If any other devices are in the vicinity of this radio,the antenna of this radio shall be no less than 10meters away
from that of such RF device.
2.2 Tools

Electric drill

Phillips screwdriver

T6 torx screwdriver