Users Manual

5
» Press the preprogrammed Operation Mode Switch key.
» If the Zone/Subgroup Switch Mode feature is enabled, you can switch the operation mode by
switching the contact through the menu or the Smart knob.
 Auto Switch
The Mode Automatic Switch feature allows the radio to automatically switch the operation mode, so as
to guarantee the normal communication of the radios in no-signal coverage areas or when the system
fails.
Go to Menu > Mode to enable Auto Switch, or press the preprogrammed Mode Auto Switch key.
2.7.1 Conventional Mode
In conventional mode, a zone is a group of channels within the same operational area. The radio receives
and transmits data and voice on the selected channel.
2.7.1.1 Selecting a Zone
 Go to Menu > Zone, select the zone, and then select Set Default.
 Press the preprogrammed Zone Up or Zone Down key.
2.7.1.2 Selecting a Channel
A channel is used to receive and transmit data and voice. Before selecting a channel, make sure that
the current zone contains the channel.
 Press and then rotate the Smart knob.
 Go to Menu > Zone, select the zone, and then select the channel.
 Press the preprogrammed Channel Up or Channel Down key.
 Press the preprogrammed Preset Channel key.
If the Voice Notify feature is enabled, the radio automatically announces the current channel upon
power-on and channel change.
2.7.2 Trunking Mode
In trunking mode, the radio automatically hunts for available base stations (BS). During hunting, the
LCD displays "Hunting...”. After registration, the radio can receive and transmit voice and data.
2.7.2.1 Selecting a Group or Private Contact
To select a group contact or a private contact, do one of the following: