Quick Reference Guide

NO. Part Name NO. Part Name
fuse)
6 Screw (4 mm x 16 mm) 13 RF Antenna
7 Microphone Hanger / /
l The RF antenna should be purchased separately.
l The GPS antenna is available only for radios
with the GPS feature.
l The palm microphone without keypad (with ⑥
and ⑦) is available for the digital radio and the
one with keypad (with ⑥ and ⑦ ) is for the
trunking radio. The handset (with ⑨ and ⑩) is
for the duplex radio.
Procedure
1. Select a location, drill holes based on the shape of the
mounting bracket, and then use the screws (4.8 mm x
20 mm) to secure the bracket.
2. Connect the RF antenna, GPS antenna,and power
cord to the radio.
3. Slide the radio into the mounted bracket and secure it
using the locking knobs.
4. Install the microphone hanger in a location where
you can reach it easily, and use the screws (4 mm x
16 mm) to secure it.
5. Align the triangle index on the palm microphone or
the handset with the installation index, plug the
connector into the radio, and rotate the connector
clockwise to secure it.
6. Place the palm microphone or the handset on the
hanger when you do not use it.
Basic Operations
Turning the Radio On or Off
To turn the radio on, long press the On-Off key.
To turn the radio off, press the On-Off key.
Adjusting the Volume
1. Press the Volume Control knob to switch to volume
control mode.
2. Rotate the Volume Control knob to adjust the
volume.
Using the Keypad
You can use the keypad on the palm microphone or the
handset to edit user aliases or IDs and text messages.
l To switch the input method between alphabetic mode
and numeric mode, press .
l To enter special characters, press in alphabetic
mode or in numeric mode.
l To enter a space, press in alphabetic mode.
Switching the Operation Mode
The radio can operate in conventional or trunking mode.
In conventional mode, you can receive and transmit voice
and data after selecting the required channel. In trunking
mode, you can receive and transmit voice and data after
the radio registers with the base station (BS)successfully.
l To manually switch the operation mode, go to
Mode>Manual Switch, or press the preprogrammed
Operation Mode Switch key.
l To allow the radio to automatically switch to
conventional mode when the signal drops below the
preset level in trunking mode, go to Mode>Auto
Switch , or press the preprogrammed Mode
Automatic Switch key.
Conventional Mode
In conventional mode, the radio receives and transmits
data and voice on the selected channel.
Selecting Zones and Channels
A channel is used to receive and transmit data and voice.
A zone is a group of channels within the same operational
area. The radio supports up to 64 zones, each of which
contains up to 256 channels.
3