Hytera Communications Corporation Limited Hytera Tower, Hi-Tech Industrial Park North, 9108# Beihuan Road, Nanshan District, Shenzhen, People's Republic of China 1.
. Before Use 2.1 Installing the SIM Card and SD Card 1. Slide the battery latch to and remove the battery cover. 2. Remove the battery. 3. Open the card slot cover. 4. Put the card into corresponding slot. 2.2 Attaching the Battery Use the approved battery to avoid the risk of explosion. Dispose of the used battery according to “Precautions for Disposal” in the Safety Information Booklet.
2.3 Charging the Battery Use the approved charger to charge the battery. Read the Safety Information Booklet before charging. The remaining lithium-ion battery power is limited to 30% pursuant to the new lithium battery shipment regulation approved by International Air Transport Association (IATA). To charge the battery, connect the terminal to the power adapter, power bank, or computer with the USB cable. To determine the charging status, check the battery icon or percentage shown on the LCD display.
2.5 Attaching the Audio Accessory Open the cover of the audio accessory connector and insert the audio accessory into the connector. To ensure optimum waterproof and dustproof performance, close the cover after removing the audio accessory.
3. Operation 3.1 Powering the Terminal On or Off To power on the terminal, press and hold the key. To power off the terminal, press and hold the key, and select Power Off. 3.2 Adjusting the Volume To increase the volume, press + key. To decrease the volume, press – key. 3.3 Turning the Screen On or Off To turn off the screen when it is on, press the SK key. To turn on the screen when it is off, press the SK key, Emergency Alarm key or any key on the keypad. 3.
3.6 Connecting to the Internet You can connect to the Internet by using the cellular network or WLAN network. To connect to the cellular network, install the SIM card and activate the cellular data service. To connect to the WLAN network, do as follows: 1. Go to to select WLAN to enable the WLAN network. 2. Choose one of the listed networks. If a password is required, enter the password and select Connect. 3.
4. PoC Service Push-to-talk over Cellular (PoC) provides direct one-to-one and one-to-many voice communication services over the cellular network. This service is available only when you have installed the PoC application on the terminal. You can access PoC menu to initiate a call. 1. Go to Home > PoC, and then press OK/Menu key. 2. Select the required contact. 3. Press and hold the PTT key and speak. You can listen to a call without any operation.
FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Innovation, Science and Economic Development Canada licence-exempt RSS standard (s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,including interference that may cause undesired operation of the device. Le onjunc areil est conforme aux CNR d’ l’innovation, la science et le développement économique Canada licables aux areils radio exempts de licence.
Les tests SAR sont effectués en utilisant des positions de fonctionnement standard acceptées par l'ISEDC avec l'appareil transmettant à son niveau de puissance certifié le plus élevé dans toutes les bandes de fréquences testées, bien que le SAR soit déterminé au niveau de puissance certifié le plus élevé, le niveau SAR réel du téléphone pendant son fonctionnement peut être bien en dessous de la valeur maximale, en général, plus vous êtes proche d'une antenne de station de base sans fil, plus la puissance de
