User's Manual

29
In TMO, you can also switch the network through the Functions menu.
You can customize your favorite functions to the terminal.
8.2 Network setting
When the signal strength of the current network is weak or the terminal is out of the coverage of the current network,
the terminal will be out of service. To continue using the terminal, you can switch to other available networks.

Manual Switch

In DMO, the network of the default group is the network of the terminal. To switch the network, switch
the default group.

In TMO, if the terminal is configured with multiple networks, go to Network > MNI List, and then select
the network.

Auto Switch
In TMO, if the terminal is configured with multiple networks, go to Network, and then select Auto Switch.
The terminal will automatically switch to another network when it is out of service.
8.3 Audio Setting
8.3.1 Audio Profile
The Audio Profile feature allows the terminal to output clear voice in various environments. This feature is only
applicable to the half-duplex call established through the internal speaker and is unchangeable during the call.
The terminal supports audio profiles listed in the following table.
Audio Profile Application
General This profile is applicable to the low-noise environment, such as a quiet street.
Quiet This profile is applicable to the indoor environment which is relatively quiet.
Noise This profile is applicable to the high-noise environment, such as a road.
Silent
This profile is applicable to the extremely quiet environment. After configuration,
the terminal emits no sounds.
Bright Audio
This profile is applicable to the environment with changeable noise level. The
terminal automatically adjusts the audio parameters based on the environment for
high quality voice.
Howling Suppression
This profile is applicable to the situation when terminal users are near to each other
(within one meter).