User's Manual

36
1.8 W (32.5 dBm).

In DMO, the maximum transmission power can be s
et to "1.8W(32.5dBm)", "1W(30dBm) ", "0.56W(27.5dBm)
", "0.3W(25dBm) ", or "0.18W(22.5dBm) ".

In TMO, the maximum transmission power can be se
t to "1.8W(32.5dBm)", "1W(30dBm) ", or
"0.56W(27.5dBm) ".
To set the maximum transmission power, on the home screen, press the Menu key, go to Settings > Function >
Power, and then select a value.
8.9 Work Type
In DMO, the terminal can switch among different work types to initiate calls or send messages. The terminal has
the following work types:

MS-MS: The terminal directly communicates with another terminal.

Repeater: The terminal can directly communicate with another terminal or communicate with another terminal
through a repeater.

Gateway: The terminal directly communicates with another terminal or communicates with another terminal
through a gateway.

GW + Rep: The terminal directly communicates with another terminal or communicates with another terminal
through a gateway or repeater.
To select a work type, on the home screen, press the Menu key, go to Settings > Work Type, and then select a
work type. After the settings, you can also further select Automatic or Specific (except MS-MS) to decide a random
or specific device that the terminal will detect.
8.10 Energy Saving Mode
In TMO, the Energy Saving Mode feature allows the terminal to receive data from the BS periodically instead of
continuously when the terminal is not transmitting or receiving. In this case, traffic on the control channel is reduced,
which saves energy.
The receiving interval is subject to the energy saving level. A higher level indicates a longer interval.
To set the energy saving level, on the home screen, press the Menu key, go to Settings > Function > Energy
Saving Mode, and then press the Left or Right key to adjust the level.