User's Manual

4 Operation
This chapter describes the procedure for the proper operation of the product at its loca-
tion.
The work steps listed in the following table must be performed for the operation of the
product.
Overview of work steps to be performed (operation)
Work steps Described in
Ä Switching on the DIB-R5 advanced Ä Chapter 4.2 “Switching on
the DIB-R5 advanced”
on page 66
Ä Function tests and
operating surveillance
Ä Checking operating states Ä Chapter 4.3.3 “Checking
operating states” on page 70
Ä Checking the availability Ä Chapter 4.3.4 “Checking
the availability” on page 72
Ä Function tests and oper-
ating surveillance GNSS
Ä Chapter 4.3.6 “Function
tests and operating surveil-
lance GNSS” on page 74
4.1 Safety measures and prerequisites
The following security measures and prerequisites must be observed for all activities:
n The site must be prepared in compliance with the document "DIB-R5 advanced Site
Requirements".
n The product must have been set up and connected according to the document
"DIB-R5 advanced Installation Manual".
n The product must have been configured according to the document
"DIB-R5 advanced Configuration Manual".
n The DIB-R5 advanced may be set up and commissioned only of the required ambient
conditions are met at all times, refer to
Ä Table “Ambient data” on page 66.
n The safety regulations must be considered at all times, refer to chapter
Ä Chapter 2
“Safety regulations” on page 13.
n Observe all other activity-based security measures and prerequisites in the work
steps in this chapter.
Ambient data
Operation Temperature range
(normal)
+5 °C to +45 °C (+41 °F to
+113 °F)
Temperature range
(extreme, as per
EN 300 394)
-30 °C to +55 °C (-22 °F to
+131 °F)
Operation
Safety measures and prerequisites
DIB-R5 advanced
65Operation Manual 90DIBR5advancedOM02 - 1.0